M306RCM CONFIGURATOR
Support for CHROME and EDGE browsers only
DETECTOR OUTPUTS
Pin 3 for IEC62955, Pin 2 for IEC62752 ⓘPin 2 for IEC62955, Pin 3 for IEC62752 ⓘ
Pin 3 Active High ⓘ
Pin 3 Active Low ⓘ
Pin 2 Active High ⓘ
Pin 2 Active Low ⓘ
DETECTION LEVELS
mA DC ⓘmA AC ⓘ
TEST INPUT
Active High ⓘActive Low ⓘ
Replicate ⓘ
Trigger ⓘ
CALIBRATION
ⓘANCILLARY OUTPUTS
mA DC range ⓘFilter time constant ⓘ
PWM
PWM Enabled ⓘPWM Disabled ⓘ
μs Hz ⓘ
3.3 Volt ⓘ
5 Volt ⓘ
μs offset at 0mA DC % Duty Cycle ⓘ
UART TX
UART on pin 2 ⓘUART disabled ⓘ
ms Update Interval ⓘ
mA AC range ⓘ
UART 9600/8-O-1
communication status
On powerup the RCM stays in configuration mode for 10sec, in this time you must 'Select COM Port' and also 'Get Serial No.' then the RCM will stay in configuration mode until power cycled.
serial number
. . .
Configuration String
. . .